HONGYANG GROUP Ecuador Technical Center

Fax: +86 (577)88097280

HONGYANG Group logo

HONGYANG GROUP Ecuador Technical Center , Discuss Technical Problem , Suply After Service Online of Fuel Dispenser, Please Regist Firstly

U101-F Heavy Duty Flowmeter


U101-F Heavy Duty Flowmeter

This Flowmeter is to measure the exact volume of the dispensed fuel. which is designed for non-commercial use only. this flowmeter is reliable ,inexpensive, simple installation and easy calibration on the workplace.


Body: teflon

seals: Buna-N

Technical Specifications:

Litre: 4 digits

Totalt: 8 digits

Flow rate range:20L~120L/min


Environmental condition:-40~~+70degree


Product ID Net Weight Cross Weight Dimension

U101-F 8kg/case of 1 9kg/case of 1 28×25×18cm/case of 1

products links


technical archives

    but also container, vacuum pump. The hose made according to GB10543 consists of inner rubber layer, enhancing layer, conductible metal line and exte fuel dispenser rior rubber layer. Whichever hose abided by the requirements of GB/T9081-2001 Fuel dispenser for vehicle and JJG443-98 Fuel Dispenser in terms of safety and accuracy. During operation pay much attention to protect hose: avoid as much crook as possible; prevent pressure on hose; avoid and reduce abrasion with ground. 4. Connection and seal about pipeline and hydraulic elements Each part of fuel dispenser adopts pipeline connection, dividing into hard type and soft type. In hard type connection steel pipe, brass pipe and aluminum pipe are adopted as pipeline, but in soft type one hose and corrugated pipe. Connected components includes relative elbow jointer, flange and directive jointer. There are following seal types: cone-shaped seal, subulate thread seal, O-ring seal, rubber and asbestos gasket, cork and rubber board, engineering rubber board. According to regulation stipulated in GB/T9081 every fuel dispenser shoul fuel dispenser d be conducted sealability testing before leaving factory, no leakage found under normal operation. As replace some parts or found leakage these problems should be paid atte fuel dispenser ntion: Cone-shaped seal structure Cone-shaped seal structure also called as expanding jointer, which is composed of pipe with outstretched end, flat spout and outside thread bushing. Sealability is ensured through tightly integration of subulate surfaces. In disassembling or reassembling cone-shaped seal structure pays much attention not to hurt or broken sublatae surfaces, cleaning waste. Thread airproof As disconnection or reassembly thread surface should be kept clean, daubing seal glue or seal belt before installation. O-ring seal Most manufacturers adopts national standard to design O-ring seal, reaching a good sealability. However, some parts is impossible to adopt national standards because of specific structure. Thus, user should purchase or employ appropri

technical specification

    In this example the Logical Node Adress (LNA) of the recipient is 24:01 (1801H) and   the LNA Originator is 02:08 (0208H). The table or fuel dispenser igianlly contain 02:01 02:02 02:05   02:99 (63H) 02:09 and 02:08. And the value 02:09 is to be removed. Extra spaces are   used to separate elements for clarity. In this example a token value of 11 (0BH) is   used.   1801 0208 02 4B 0006 0100 0C 02 0209   The correct acknowledge message is: 0208 1801 00 EB 0003 010000   To check it has been removed a read of the Recipient Address Table is performed in   this example a token value of 6 (06H) is used.   1801 0208 02 06 0003 0100 03   The correct answer response is   0208 1801 00 26 0084 01000380 0201 0202 0205 0263 0000 0208 0000 0000   0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000   0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000   0000 0000 0000 0000 0000 0000 0000 0000 0000 fuel dispenser 0000 0000 0000 0000 0000   0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000   Note the Originator cannot assume the table has b fuel dispenser een resorted.  February 2006 IFSF - STANDARD FORECOURT PROTOCOL FP2_1.90   COMMUNICATION SPECIFICATION   Page: 35  4.5.3 Heartbeat   Heartbeat message On the network (Sent by any equipment)   Broadcast On Domain 1   LNAO (Originator Subnet + Node)   IFSF_MC = 1   DEVICE_STATUS bin8 (0-255)   bit 1 = Configuration Needed   bit 2-7 = Reserved for future use  

we are committed to create the best workplace, encourage our staffs to put their own personalities into their jobs, and provide them a stage to show themselves.

    heir NDCs earn interest at a rate broadly equivalent to the growth of the payroll-tax base. When employees retire, their notional capital is converted fuel dispenser into regular pension annuities in a similar way to funded plans—except that the annuities are paid out of taxes on tomorrow s workers, not their own retirement savings. This reform offers a way round a difficult problem. As the costs of traditional pay-as-you-go systems rise, so do the taxes needed to pay for them. But more onerous taxes on labour are likely to discourage work and thus constrict the tax base from which the pensions are supposed to be paid. Notional accounts set an automatic limit to the claims of tomorrow s pensioners on tomorrow s workers. They do this by insulating public pensions from two demographic trends that are weighing on traditional systems. First, the value of notional accounts responds automatically to rising longevity the annuities that pensioners receive depend on their life expectancy at retirement. Second, the accounts vary with the birth rate a low rate will eventually feed fuel dispenser through to the payroll-tax base through stagnant or falling employment. This will hold down returns on NDCs and hence pensions. Rises in productivity growth, however, wil fuel dispenser l work in the other direction. In effect, notional accounts force the adjustment caused by demographic change on to benefits rather than contributions. The obvious drawback is that pensions may turn out to be inadequate. The answer to that is to work longer indeed, notional accounts automatically encourage people to retire later as populations age. Subject to a minimum age, individuals can decide for themselves whether they want to stop work earlier with a lower pension, or later with more. Indeed, NDCs should spur people of all ages to work, since their pensions directly reflect their contributions. Unlike traditional benefits, which are only loosely linked to lifetime contributions, the annuities from notional accounts are actuarially fair you get out what yo