HONGYANG GROUP Ecuador Technical Center

Fax: +86 (577)88097280

HONGYANG Group logo

HONGYANG GROUP Ecuador Technical Center , Discuss Technical Problem , Suply After Service Online of Fuel Dispenser, Please Regist Firstly

D-GB66Q FUEL DISPENSER

D-GB66Q

D-GB66Q FUEL DISPENSER

FlowMeter Type : Optional

Accuracy :±0.2%

Pressure Loss (kg/cm): Under 0.25

Motor Voltage(V) :110V/220V/380V,50Hz/60Hz

Capacity(hp) :1HP(0.75kw)

Input Voltage : 110V/220V/380V,50Hz/60Hz

Nozzle :Auto Shut-off Nozzle

Environmental Condition :-40~~+55degree

Control Type : Solenold Vale Control Type

Preset : Function Provided(Small LCDIndicator)

Display(Counter) :Type LCD and Bright Backlight

Digit of Volume :0~~999,999(6 Digits),Decimal point can be changed

Digit of Amount : 0~~999,999(6 Digits),Decimal point can be changed

Digit of Unit price : 0~~9999(4 Digits),Decimal point can be changed

Digit of Total Range :0~~99,999,999,99

Optional Display Type: LCD and Bright Backlight

Digit of Volume : 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Amount : 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Unit price : 0~~999999(6 Digits),Decimal point can be changed

Digit of Total Range :0~~99,999,999,99

Totalizer :1~~9,999,999

Hose: 4.5m

Weight: 405kg

Dimension(L×W×H) : 1270 x 620 x 2420(mm)

Dimension(L×W×H)Of Qty of Container : 40ft: 28 20ft: 13

products links

links

technical archives

    ws into pipe because of adapting one pipe fuel dispenser in two fuel dispensers or other leakage. Bottom valve in tank or single valve in pipeline is stuck and damaged, no oil into pump. Oil level is lower than bottom valve or suction nadir. Counter at beginning of operation Due to long and much soft, hose tends to bulge under a certain pressure. Transducer will count as bulging pressure out of certain scope. This trouble can’t be solved through shorten or replace hose. As leakage in bottom valve or pipe, oil flow back into tank between operation interval because of lower oil level in vapor separator and pump. Air in transducer drives to count as next time refueling. The longer interval time the more data jump. Inspect and solve pipeli fuel dispenser ne leakage of oil and air. Unstable flow rate makes large tolerance; air leakage in bottom valve and pipe oil level low than bottom valve bring about much air flow into fuel dispenser. Article III Important notices to dispenser’s maintenance Due to fuel dispenser located in flammable and combustible location, operator should pay much attentions to security preventing accident occur on human and equipment, and strictly abide by the following general requirements: Smoking and open flame is strictly prohibited in filling station in case lead to fire. Maintainer should, in accordance with safety regulations in filing stati fuel dispenser on, not wear shoes with metal nail and chemical fiber easy to generate static. Cut power supply prior to maintain fuel dispenser; pick down V belt then empty oil filled in part where need to be done. Pour oil into container in case of splash out. Repairing tools should be explosion-proof, prohibiting randomly throw in case of generating spark and accident. Pay much attention not to the joint surfaces of seal and metal parts, which would lead to leakage. All components and sections should be cleaned so to prevent giblets or waste destroying parts. Carefully inspect wire connection after maintaining electric equipment, abstaining new trouble.

technical specification

    area of the hydraulic housing at the base fuel dispenser of the   metering pump dispenser or remote pumping unit. At least 50% of this minimum ventilation area shall be at the   lower part of the housing. The total minimum area shall be divided between opposite sides of the housing such that   the ratio of the areas is in the range 0 9 to 1 1.   5.3.7.3 Hose cassette   Cross ventilation of the inside of a hose cassette housing shall be provided and the total effective area of the   2   ventilation openings shall be not less than the greater of 8 000 mm or 3 5 % of the maximum horizontal int fuel dispenser ernal   cross-sectional area of the hose cassette at the base of the metering pumpdispenser. At least 50 % of this   minimum ventilation area shall be at the lower part of the hose cassette housing. The total minimum area shall be   divided between opposite sides of the hose cassette housing such that the ratio of the areas is in the range 0 9 to   1 1.   The hose cassette shall be separated from the hydraulic housing by a wall with a degree of protection not less than   IP2x.   5.3.7.4 Enclosures partially in a hazardous area   fuel dispenser Enclosures partially in a hazardous area see 5.2.1.5 b) shall be provided with well distributed cross ventilation in   2   the non-hazardous area of at least 10 mm .   -- - - ---   28       5.3.7.5 Column extensions   5.3.7.5.1 Column extensions above vapour barriers   Column extensions of the

we are committed to create the best workplace, encourage our staffs to put their own personalities into their jobs, and provide them a stage to show themselves.

    g contested. In an odd coincidence, it is fuel dispenser the seat Ms Harris decided to vacate to pursue a disastrous Senate run. Initial results showed a narrow lead for the Republican, Vern Buchanan. A recount gave him a 369-vote victory. Good enough to settle the matter in some circumstances, but not these. Sarasota County, one of four (plus a fragment of a fifth) that make up the district, had an abnormally high The perils of technology rate of “undervotes?in the race. More than 18,000 of its ballots recorded no vote for Mr Buchanan or the Democrat, Christine Jennings. That meant that 13% of Sarasota voters failed to choose a House candidate, compared with roughly 2% in neighbouring counties. Sarasotans cast more votes for the hospit fuel dispenser al board than they did for their representative in Washington. Because the machines provide no paper record, no one can say for sure whether the missing votes, if counted more carefully, could have changed the outcome. But pre-election polls showed Ms Jennings in the lead. If the missing votes split at the same rate as the rest of the county, she would easily have won. Ms Jennings has filed a lawsuit asking for a re-run. Officials at first downplayed the story. “I m not sure there s even a problem,?said a spokeswoman for the secretary of state, theorising that voters sat out the race to protest against negative campaignin fuel dispenser g. But everyone in the district saw the same nasty ads and the pronounced undervote was limited to Sarasota County. Working out what went wrong will be complicated. In court filings, Ms Jennings attributed the undervote to “pervasive malfunctioning of electronic voting machines? The state made election workers re-cast thousand of ballots to test the machines. Discrepancies abounded, but this only proved that there were problems during the test. “Florida election officials? sighed one local paper, “now have two mysteries to solve.?Many are blaming a poor ballot design in Sarasota that squeezed the House race onto the same